Normal Playback; Preparing For Playback; Listening To A Source Component - Kenwood VR-8070 Instruction Manual

Normal playback

Preparing for playback

Some preparatory steps are needed before starting playback.
POWER
ON/STANDBY
SPEAKERS
MD/TAPE
Turning on the receiver
1 Turn on the power to the related components.
2 Turn on the power to this receiver by pressing the POWER
ON/STANDBY key.
Selecting the input mode
If you have selected a component connected to the CD/DVD, VIDEO 2,
VIDEO 3 or DVD/6CH jacks, make sure that the input mode setting is
correct for the type of audio signal to be used.
Selecting MD/TAPE
Select the source name corresponding to the component connected
to the MD/TAPE jacks. The initial factory setting is "TAPE". To
change the source to "MD", follow the steps below:
Hold down the MD/TAPE key for more than 2 seconds.
• The source indication changes to "MD".
• To return to the original indication, repeat the above procedure.
Selecting the speaker system
Press the SPEAKERS key to select the speaker system to be
used.
A ON : Sound from the speakers connected to the SPEAKERS A
terminals on the rear panel.
B ON : Sound from the speakers connected to the SPEAKERS B
terminals on the rear panel. No sound will be heard from
the subwoofer.
A+B ON : Sound from both the speakers connected to the
SPEAKERS A and B terminals on the rear panel.
A+B OFF : No sound from the speakers. Use this setting when
listening with headphones for stereo sound in all playback
modes. The display segments are different depending on
the type of input signal.
The indicator for the speakers
you want to use should be lit.
SP
A B
L C R
LFE
SL S SB SR
• Selecting "6CH INPUT" by pressing the INPUT MODE key, whereby
"DVD/6CH" is the input source will cause SPEAKERS A to be selected
automatically.
24
EN
INPUT MODE
MUTE OPTICAL 6CH INPUT CIN
AUTO DETECT
ACT
CLIP
COAXIAL ANALOG 96kHzfs DS

Listening to a source component

Input Selector
1
Use the Input Selector and AV AUX key to select the
source you want to listen to.
8
Selecting a source using each key.
1 "DVD/6CH"
2 "CD/DVD"
3 "PHONO"
4 "TUNER"
5 "VIDEO 1"
6 "VIDEO 2"
7 "VIDEO 3"
8 "MD/TAPE"
9 "AV AUX"
2
Start playback from the selected source.
3
Use the VOLUME CONTROL knob or VOL +/ – keys to adjust
the volume.
VOLUME CONTROL
AV AUX
Input Selector
VOL /