Kenwood VR-8070 Instruction Manual page 21

Preparing for surround sound
7 Press the key or # key again to accept the setting.
∧ ∧ ∧ ∧ ∧
• The Surround Speaker indication "SURR" appears.
8 Use the MULTI CONTROL knob or Multi (%/fi) keys to select
the appropriate Surround Speaker setting.
If you selected "LARGE" as the Center Speaker setting,
1 SURR NML/THX : Average size Surround Speakers are
2 SURR LARGE
3 SURR OFF
If you selected other than "LARGE" as the Center Speaker
setting,
1 SURR NML/THX : Average size Surround Speakers are
2 SURR OFF
• When the setting "SURR OFF" is selected, you may skip to step
!.
9 Press the key or # key again to accept the setting.
∧ ∧ ∧ ∧ ∧
• The Surround Speaker setting indication "SB" appears.
0 Use the MULTI CONTROL knob or Multi (%/fi) keys to select
appropriate Surround Back Speaker setting.
If you selected "LARGE" as the Surround Speaker setting,
1 SB NML/THX : Average size Surround Back Speaker is
2 SB LARGE
: Large Surround Back Speaker is con-
3 SB OFF
: Surround Back Speaker setting mode to
SP MUTE OPTICAL 6CH INPUT
AUTO DETECT
A B CLIP
COAXIAL ANALOG
L C SW R
LFE
SL S SB SR
If you selected "NML/THX" as the Surround Speaker setting,
1 SB NML/THX : Average size Surround Back Speaker is
2 SB OFF
: Surround Back Speaker setting mode to
! Press the key or # key again to accept the setting.
∧ ∧ ∧ ∧ ∧
• The Subwoofer re-mix setting indication "SW RE-MIX" ap-
pears.
@ Use the MULTI CONTROL knob or Multi (%/fi) keys to select
the appropriate Subwoofer re-mix setting.
1 SW RE-MIX ON : Subwoofer re-mix setting mode to
2 SW RE-MIX OFF : Subwoofer re-mix setting mode to
• If subwoofer is turned off, subwoofer re-mix setting is not visible.
# Press the SETUP key again to return to the main setup
displays.
connected to the receiver.
: L a r g e S u r r o u n d S p e a k e r s a r e
connected to the receiver.
: Surround Speaker setting mode to
the receiver is OFF.
connected to the receiver.
: Surround Speaker setting mode to
the receiver is OFF.
connected to the receiver.
nected to the receiver.
the receiver is OFF.
CINEMA EQ. DTS. DOLBY DIGITAL STEREO NEO:6
THX
ACTIVE EQ. MATRIX
Surround EX
96kHzfs DSP MODE DISCRETE PRO LOGIC LOUDNESS CSII
connected to the receiver.
the receiver is OFF.
the receiver is ON.
the receiver is OFF.
5
Adjust the speaker volume level.
From your usual listening position, adjust the volume levels. The
volume levels from each speaker should be the same.
• The receiver enters the speaker volume level adjustment mode.
• Indicators appear only for the channels of the speakers selected
in step 4.
Be aware that the TEST TONE is quite a loud sound (0dB).
1 Press the ∧ ∧ ∧ ∧ ∧ /∨ ∨ ∨ ∨ ∨
2 Press the SETUP key for the following displays:
1 T.TONE AUTO
2 T.TONE MANUAL
3 The selection of AUTO/MANUAL TEST TONE is done by the
MULTI CONTROL knob or Multi (%/fi) keys.
Press the SETUP key again to begin TEST TONE.
Use the MULTI CONTROL knob or Multi (%/fi) keys to adjust
the volume level of the test tone output from the speaker
channel to be adjusted.
For AUTO selection, the first test tone is heard from the Front
Left Speaker for 2.5 seconds. The next test tone is heard from
the speakers in the following sequence for 2 seconds each.
LEFT
SUBW
The channel indication blinks while the test tone is being output.
SP
A B
L C SW R
LFE
SL S SB SR
• If you change the volume level settings for the speakers while
listening to music, the settings referred to on this page are also
RDS
RTY
changed.
AUTO
MEMO
• If the speaker setting selects are OFF, the speaker level settings
STEREO
TUNED
are reset.
For MANUAL selection, press the
time to select the speaker channel.
4 Press the SETUP key again.
• The test tone is turned off and return to the main setup displays.
6
Adjust the bass peak level.
A restriction is put on the low frequency so that the bass peak level
will not go higher than the acceptable level when the volume is
increased.
If Subwoofer is OFF, the limitation will affect the low frequency of
the Front Left and Right Speakers.
1 Press the ∧ ∧ ∧ ∧ ∧ / ∨ ∨ ∨ ∨ ∨ keys or @ / # keys to select BASS PEAK and press
the SETUP key.
SP
A B
SW
LFE
2 Use the MULTI CONTROL knob or Multi (%/fi) keys to adjust
the bass peak level to –30dB.
• The adjustment range is from – 30dB to 0dB and OFF.
keys or @/#keys to select TEST TONE.
CNTR RIGHT
SL SBL
MUTE OPTICAL 6CH INPUT CINEMA EQ. DTS. DOLBY DIGITAL
AUTO DETECT
ACTIVE EQ. MATRIX
CLIP
COAXIAL ANALOG 96kHzfs DSP MODE DISCRETE PRO LOGIC LOUDNESS
keys or @/# keys each
∧ ∧ ∧ ∧ ∧ /∨ ∨ ∨ ∨ ∨
MUTE OPTICAL 6CH INPUT CINEMA EQ. DTS. DOLBY DIGITAL
AUTO DETECT
ACTIVE EQ. MATRIX
CLIP
COAXIAL ANALOG 96kHzfs DSP MODE DISCRETE PRO LOGIC LOUDNESS
Continued to next page.
SR
SBR
STEREO NEO:6 RDS
THX
RTY
Surround EX
CSII
AUTO
MEMO
STEREO
TUNED
fi
RDS
STEREO NEO:6
THX
RTY
Surround EX
CSII
AUTO
MEMO
STEREO
TUNED
21
EN