Preparing For Surround Sound; Before Setting Up The Speakers - Kenwood VR-9080 Instruction Manual

Preparing for surround sound

Before setting up the speakers

For the optimum surround playback, variety of speaker settings are
necessary.
Following the procedure below, go through the settings described in
further pages.
(POWER
ON/STANDBY)
MEMORY/ENTER
POWER ON/OFF
(KRF-X9090D)
1
When performing "Setting up the speakers automatically
(AUTO SETUP)", connect the provided microphone for setup
to the SETUP MIC jack.
2
Turn on the power to this receiver by pressing the
ON/STANDBY) key (VR-9080) or the POWER ON/OFF key and
(POWER ON/STANDBY) key (KRF-X9090D), or the RECEIVER
ON key.
3
If you want to use the remote control unit, press the RCV
MODE key on the remote control unit to set it to the receiver
control mode.
4
Press the SETUP key to enter the SETUP mode.
Use the 5 / ∞ keys or MULTI @ / # keys for the following dis-
plays.
1 AUTO SETUP
2 MANUAL SETUP
3 SW RE-MIX
4 CROSSOVER
5 SB SPACING
6 BASS PEAK
7 LFE LEVEL
8 AUDIO DELAY
9 DISPLAY MODE
0 SETTING LOCK
- EXIT
The flow of the SETUP is as follows:
20 EN
SETUP MULTI CONTROL
SETUP
MIC
AUTO SETUP
CALIBRATE
CONFIRM
TEST SIG LVL
RETURN
MANUAL SETUP
SP SETUP
SP LEVEL
(POWER
SP DISTANCE
RETURN
SW RE-MIX
CROSSOVER
SB SPACING
BASS PEAK
LFE LEVEL
AUDIO DELAY
DISPLAY MODE
SETTING LOCK
EXIT
START RETURN
Measuring ERROR
MESSAGE
Analyzing
WARNING
COMPLETE
MESSAGE
T. TONE
AUTO
T. TONE
MANUAL
T. TONE
OFF
RETURN