Preparing For Surround Sound; Before Setting Up The Speakers - Kenwood KRF-X9090D Instruction Manual

Preparing for surround sound

Before setting up the speakers

For the optimum surround playback, variety of speaker settings are
necessary.
Following the procedure below, go through the settings described in
further pages.
1
When performing "Setting up the speakers automatically
(AUTO SETUP)", connect the provided microphone for setup
to the SETUP MIC jack.
2
Turn on the power to this receiver by pressing the POWER
ON/OFF key and (POWER ON/STANDBY) key, or RECEIVER
ON key.
3
If you want to use the remote control unit, press the RCV
MODE key on the remote control unit to set it to the receiver
control mode.
4
Press the SETUP key to enter the SETUP mode.
Use the 5 / ∞ keys or MULTI @ / # keys for the following dis-
plays.
1 AUTO SETUP
2 MANUAL SETUP
3 SW RE-MIX
4 CROSSOVER
5 SB SPACING
6 BASS PEAK
7 LFE LEVEL
8 AUDIO DELAY
9 DISPLAY MODE
0 SETTING LOCK
- EXIT
The flow of the SETUP is as follows:
AUTO SETUP
CALIBRATE
START
Measuring
Analyzing
COMPLETE
CONFIRM
TEST SIG LVL
RETURN
MANUAL SETUP
SP SETUP
SP LEVEL
SP DISTANCE
RETURN
SW RE-MIX
CROSSOVER
SB SPACING
BASS PEAK
LFE LEVEL
AUDIO DELAY
DISPLAY MODE
SETTING LOCK
EXIT
RETURN
ERROR
MESSAGE
WARNING
MESSAGE
T. TONE
AUTO
T. TONE
MANUAL
T. TONE
OFF
RETURN
19 EN