Dual Zone System - Kenwood KDC-6047U Instruction Manual

Dual Zone System

Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
Display Overview
"2Zone Rear Volume"* Adjust the volume of Rear channel.
1
"0" — "35"
"Detailed Setup"
"2Zone" Sets the Dual Zone System.
"OFF"/ "ON"
"2Zone Select"* Specifies the destination of sub source sound
1
when the Dual Zone function is turned on.
"Rear"/ "Front"
* The Dual Zone System is set to "ON".
1
1
Select the source
Press the [SRC] button. Turn the [VOL] knob and
press it when the desired item is displayed.
Select a source other than "STANDBY".
✍ SRC Select mode 2: Pressing the [SRC] button
repeatedly switches source.
2
Enter Audio Control mode
Press the [VOL] knob.
3
Turn the [VOL] knob and press it when the
desired item is displayed.
Select "Detailed Setup".
4
Select the item you want to set
Turn the [VOL] knob and press it when the
desired item is displayed.
5
Exit Audio Control mode
Press the [MENU] button for at least 1 second,
and then press it again briefly.
⁄
• Select Main source by [SRC] button.
• Adjust the volume of Front channel by [VOL] knob.
• The Audio Control has no effect on sub source.
• There are following limitations when Dual Zone System
is enabled.
- There is no output from the subwoofer.
- "Fader", "Subwoofer Level" of
and DSP function are not available.
• The Bluetooth audio source can be set exclusively to the
front speaker. Set "2Zone Select" to "Rear".
( : Factory setting)
<Audio Control> (page 36)
39
|
English