Dual Zone System - Kenwood KIV-BT901 Instruction Manual

Dual Zone System

The separate sources can be selected for Front
channel and Rear channel.
Display Overview
"2Zone Rear Volume"* 1 Adjust the volume of Rear channel.
"0" — "35"
"Detailed Setup"
"2Zone Select" The Dual Zone System is enabled by selecting
a sub source.
"OFF"/ "USB" ("iPod"/ "Zune")/ "INT
MEM"/ "AUX"
"2Zone Front/Rear"* 1 Specifies the destination of sub source sound
when the Dual Zone function is turned on.
"Rear"/ "Front"
* The Dual Zone System is enabled.
1
1
Select the source
Press the [SRC] button repeatedly also switches
source.
Select a source other than "
✍ SRC Select mode 2: Press the [SRC] button. Turn
the [Volume] knob and press it when the desired
item is displayed.
2
Enter Audio Control mode
Press the [Volume] knob.
3
Turn the [Volume] knob and press it when the
desired item is displayed.
Select "Detailed Setup".
4
Select the setting item to adjust
Turn the [Volume] knob and press it when the
desired item is displayed.
5
Make a setting
Turn the [Volume] knob to select a setting
value, and then press the [Volume] knob.
6
Exit Audio Control mode
Press the [MENU] button for at least 1 second.
⁄
• Select Main source by [SRC] button.
• Adjust the volume of Front channel by [Volume] knob.
• The Audio Control has no effect on sub source.
• "USB", "iPod", "Zune" and "Int.Mem. " (Internal memory)
cannot be set at the same time for the main and sub
sources.
• There are following limitations when Dual Zone System
is enabled.
- There is no output from the subwoofer.
- "Fader", "SubWoofer Level" of
and DSP function are not available.
( : Factory setting)
STANDBY".
<Audio Control> (page 46)
• The Bluetooth audio source can be set exclusively to the
front speaker. Set "2Zone Front/Rear" to "Rear".
• The source set as a sub source cannot be operated
during the dual zone mode. Cancel the mode and then
operate the source.
49
|
English