Dual Zone System - Kenwood DPX404U Instruction Manual

Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
Display Overview
"2Zone Rear Volume"* Adjust the volume of Rear channel.
"0" — "35"
"Detailed Setup"
"2Zone" Sets the Dual Zone System.
"ON"/ "OFF"
"2Zone Select"* Specifies the destination of sub source sound
when the Dual Zone function is turned on.
"Rear"/ "Front"
* The Dual Zone System is set to "ON".
1
Select the source
Press the [SRC] button.
Select a source other than "STDBY".
2
Enter Function setting mode
Press the [VOL] knob.
3
Turn the [VOL] knob and press it when the
desired item is displayed.
Select "Audio Control"
4
Select the item you want to set
Turn the [VOL] knob and press it when the
desired item is displayed.
5
Exit Function setting mode
Press the [ ] button for at least 1 second.
⁄
•
Select Main source by [SRC] button.
•
Adjust the volume of Front channel by [VOL] knob.
•
The Audio Control has no effect on sub source.
•
There are following limitations when Dual Zone System is
enabled.
- There is no output from the subwoofer.
- "Fader", "SubWoofer Level" of
DSP function are not available.
•
The Bluetooth audio source can be set exclusively to the
front speaker. Set "2Zone Select" to "Rear".
( : Factory setting)
>
"Detailed Setup".
<Audio Control> (page 48) and
51
|
English