Connecting Wires To Terminals - Kenwood DPX-4010 Instruction Manual

Connecting Wires to Terminals

FM/AM antenna input
To car light control switch
When using the optional power
amplifier, connect to its power
control terminal.
Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for
the booster amplifier of the film-type antenna.
Ignition key
switch
Car fuse
box
(Main
Car fuse box
fuse)
Battery
+ –
2WARNING
If you connect the ignition wire (red) and the battery wire
(yellow) to the car chassis (ground), you may cause a short
circuit, that in turn may start a fire. Always connect those
wires to the power source running through the fuse box.
Fuse
(10A)
Automatic illumination/Dimmer
control wire (Orange)
ILLUMI
Power control wire
(Blue/White)
P.CONT
Motor antenna control wire
(Blue)
ANT
CONT
ACC
Ignition wire (Red)
ACC
Battery wire (Yellow)
BATT
Ground wire (Black) - (To car chassis)
— 30 —
M4 8mmMAX
FUSE 10A
KENWOOD disc changer control input
NOTE
To connect the Disc changer,
consult your Disc changer manual.
Wiring harness
(Accessory#)
White/Black
–
FRONT•L +
White
Gray/Black
–
+
FRONT•R
Gray
Green/Black
–
+
REAR•L
Green
Purple/Black
–
+
REAR•R
Purple
2CAUTION
When only two speakers are being connected to the
system, connect the connectors either to both the front
output terminals or to both the rear output terminals (do not
mix front and rear). For example, if you connect the +
connector of the left speaker to a front output terminal, do
not connect the - connector to a rear output terminal.
Front left output (White)
Front right output (Red)
Rear left output (White)/
Non-fading left output (White)
Rear right output (Red)/
Non-fading right output (Red)
To front left
speaker
To front right
speaker
To rear left
speaker
To rear right
speaker