Selecting Display Mode; Dimmer Level Adjustment; Touch Sensor Tone; Switching Preout - Kenwood DPX-4010 Instruction Manual

Function items in Standby mode:

Selecting Display Mode

The Display Mode sets the number of display colours used by
the Spectrum Analyser.
Display and setting:
"DISP MODE A" : The display can be set to use three colours:
white, light blue and blue.
"DISP MODE B" : The display can be set to use two colours:
white and blue.

Dimmer Level Adjustment

You can adjust the Dimmer level of the unit when your car's
light switch has been turned on.
Display and setting:
"DIM STEP 1" – "DIM STEP 5"
NOTE
This function is available when the dimmer wire is connected and
the light switch of your car is turned on.

Touch Sensor Tone

This function produces a beep sound that accompanies button
operation. It can be switched on or off.
Display and setting:
"BEEP On" : Beep setting is on.
"BEEP Off" : Beep setting is off.
NOTE
The beep sound is not output from the preout jacks.

Switching preout

Switch the preout between the rear and non-fading. The
factory default is rear preout.
Display and setting:
"Preout Rear" : Rear preout
"Preout N-F" : Non-fading preout
Function items in Tuner mode:

Selecting Tuning Mode

You can choose from three tuning modes: auto seek, preset
station seek, and manual. The "AUTO 1" indicator lights up
when auto seek tuning is selected, and the "AUTO 2" indicator
lights when preset station seek tuning is selected.
Display and setting:
"Auto1 Seek" : Auto seek tuning mode
"Auto2 Seek" : Preset station seek tuning mode
"Manual Seek" : Manual tuning mode
— 25 —