Presetting Disc Names (Dnps) - Kenwood DPX-4010 Instruction Manual

Presetting Disc Names (DNPS)

Store the names of discs to be displayed when played.
1
Play the disc whose name you want to preset.
NOTE
• This function is available only for the CD player of this unit and
disc changers that feature the Disc Name Preset function.
• This procedure is not to be used to store the disc and track
titles for MDs that you record.
• This function cannot be available during the clock display and
while using disc scan or magazine random play.
2
Press the NAME.S button for at least two seconds.
"Name Set" is displayed and the disc name preset mode is
entered.
The cursor blinks in the position where character input can be
made.
3 Press either the 4 or ¢ button to move the cursor to the
desired position.
The 4 button moves the cursor to the left, and the ¢
button to the right.
4
Each time the 38 button is pressed, the characters to be
entered change as listed below.
+ –
Press the DISC or DISC button to display the desired
character.
Characters that can be displayed are as follows.
Alphabet (upper case)/Numerals/Symbols:
A ~ Z 0~9 / + – * = < > [ ]
Alphabet (lower case)/Numerals/Symbols:
a ~ z 0~9 / + – * = < > [ ]
NOTE
The operation and characters that can be entered may change
as listed below, depending on the unit that is connected.
A press of the 38 button exits the disc name preset mode.
Operations can be followed again from Step 2 at a time such
as this, and the characters to be input are selected using the
procedure described below.
+
Press the DISC or DISC
character. Besides the alphabet (capital letters only) and
numbers, you can choose the following characters: /,
=, <, >, [ and ].
5
Continue steps 3 and 4 until all the characters are chosen for
the name.
NOTE
You can enter up to 8 characters for each name.
6
Press the NAME.S button.
The disc name is stored and the disc name preset mode is
canceled.
If you make no entry in a 10-second period, the name will be
stored with the characters input so far.
NOTE
• The number of discs whose names can be stored will differ
depending on the disc changer that is connected. Please see
your disc changer manual for details.
Up to 10 CDs can be registered with this unit.
• Discs are identified by their total length and number of tracks. If
another disc happens to have the same specifications as one
that you have already stored a name for, the name will be
displayed for it, too.
• If you want to change the name of a disc, repeat steps 1 and 2
to display the name, and then repeat steps 3 and 4 to input the
changes.
• Pressing the reset button erases the disc names stored in this
unit, but does not erase names stored in a disc changer.
• Each source (CD,DISC-CH1,DISC-CH2) has its own memory in
which to store the disc names.
Discs that have been disc name preset with the CD player will
not have their disc name displayed when played on a CD
changer.
— 21 —
–
button to display the desired
+ –
, , ,