Table of Contents
Advertisement
2.5.12 Other: Firmware Upgrade
From this section it is possible to update the FW of the MTX-StarEnergy-M whenever necessary.
Just press the "Select File" button and choose the firmware file with which to update the equipment. After
that, the "Upload" button must be pressed.
The update process will take approximately 2 minutes.
3. AT Commands
The MTX-StarEnergy-M firmware allows you to send AT commands directly to the internal modem
(QUECTEL) through multiple interfaces:
• By SMS
• Via Telnet/SSH (remote console)
• Using webserver
• Via SNMP
Therefore, at your own risk, you can send AT commands to the MTX-StarEnergy-M. The accepted AT
commands are those indicated in the QUECTEL module AT command manual plus some additional ones
listed below:
AT^MTXTUNNEL=REBOOT
Action: reset the MTX-StarEnergy-M
AT^MTXTUNNEL=VERSION
Action: returns the firmware version of the MTX-StarEnergy-M
30
contact@webdyn.com |
V1.0 subject to changes | Webdyn © by Flexitron Group
webdyn.com
Advertisement
Table of Contents
