Table of Contents
Advertisement
2.5.4 Other: Time Server (NTP)
The MTX-StarEnergy-M has a real-time clock inside that allows it to keep the time even after power loss.
Periodically, this internal clock needs to be synchronized with time servers through the NTP protocol if
you want to keep the device on time.
• Enabled: check this box if you want to use NTP time servers
• NTP Server 1: IP or DNS address of time server 1
• NTP Server 2: IP address or DNS of time server 2
• Time Zone: specify the time zone
ADDITIONAL NOTES
• Once the configuration is finished, press the "SAVE CONFIG" button to save the changes.
Remember that you must restart the device for the new changes to take effect
2.5.5 Other: Remote Console (TCP Server)
If at any time you need to perform a special remote operation on the MTX-StarEnergy-M, you can also do
it through a "Telnet or SSH type" connection, you can do it by configuring this section. That is, with this
special connection you can, by sending AT commands through a telnet-type connection, make a device
configuration change, reset it, etc. In other words, the same thing that can be done by SMS messaging
but by IP connection.
• Enabled: check this box if you want to use this special connection
• TCP Port: TCP listening port, where you must make the connection
21
contact@webdyn.com |
V1.0 subject to changes | Webdyn © by Flexitron Group
webdyn.com
Advertisement
Table of Contents
