Table of Contents
Advertisement
6 CONTROLS
6.6
WARNING SCREENS__________________________________________________
When malfunctions occur, the following warning screens are displayed.
6.6.1 SLOPE ANGLE DISPLAY______________________________________________
During work, if the machine is driven on a slope of 16° the machine angle
will be displayed in the centre of the screen, until the machine has been
driven onto an area of less than 16°.
6.6.2 WARNING MAXIMUM SLOPE ANGLE EXCEEDED _________________________
If the slope angle reaches 19° the screen will display this warning to indi-
cate that the machine's safe working angle has been reached.
6.6.3 WARNING SLOPE ANGLE – INHIBIT LIFT ________________________________
If the slope angle reaches 21° the screen will display this warning which
indicates that the cutters will be prevented from starting if not already run-
ning, or re-started if running then stopped. An audible warning will be
sounded four times at 4 second intervals, and the red LEDs will flash four
times at 4 second intervals. This will continue until the machine has been
driven to an area of less than 19°.
en-46
1234
123.4 Hours
P
16
TM
19
1/1
21
1/1
Advertisement
Table of Contents
