Unsatisfactory Results; General Problems Or Technical Faults - Miele KM 7200 FR Operating And Installation Instructions

Unsatisfactory results

Problem
The food in the pan
hardly heats up or does
not heat up at all when
the Auto heat-up
function is switched on.

General problems or technical faults

Problem
The cooktop or cooking
zones do not switch on.
A smell and vapours are
given off when the new
appliance is being used.
A noise can be heard
after the appliance is
switched off.
Possible cause and remedy
There is too much food in the pan.
 Start cooking at the highest power level and then
turn down to a lower one manually later on.
The pan is not conducting heat properly.
 Use a different pan which is better able to conduct
heat.
Possible cause and remedy
There is no power to the cooktop.
 Check if the circuit breaker has tripped. Contact
an electrician or Miele (for the minimum fuse
rating, see data plate).
There may be a technical fault.
 Disconnect the appliance from the mains
electricity supply for approx. 1 minute. To do this:
– switch off at the wall socket and withdraw the
plug, or
– switch off at the residual current device.
 If, after switching the circuit breaker or residual
current device back on, the appliance will still not
switch on, contact a qualified electrician or Miele.
The metal components have a protective coating.
When the appliance is used for the first time, this
causes a smell and possibly also vapour. The
material from which the induction coils are made also
gives off a smell in the first few hours of operation.
This smell will be less noticeable with each
subsequent use before dissipating completely. The
smell and any vapours given off do not indicate a
faulty connection or appliance and they are not
hazardous to health.
The fan will continue running until the cooktop has
cooled down. It will then switch itself off
automatically.
Problem solving guide
55