Operating and installation instructions Gas cooktops To prevent the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time. en-AU, NZ M.-Nr. 09 317 810...
For trouble-free operation of the appliance, it is best to use it in the countries specified for use. For use in other countries, please contact Miele in your country.
Contents Warning and Safety instructions................ 5 Caring for the environment ................ 15 Overview....................... 16 Cooktop......................... 16 KM 3034 ......................16 KM 3054 ......................17 Control knobs......................18 Burner........................19 Minute minder controls / indicators............... 20 Accessories supplied .................... 21 Before using for the first time ................ 22 Cleaning the cooktop for the first time..............
Safety instructions for installation ................. 41 Safety distances....................42 Detailed dimensions ....................45 Installation notes ....................47 Installation dimensions..................48 KM 3034 ......................48 KM 3054 ......................49 Installation ......................50 Gas connection ..................... 52 Electrical connection ..................... 55 Burner ratings ...................... 56 Conversion to another type of gas ..............
“Installation”, as well as in the “Warning and Safety instructions”. Miele cannot be held liable for injury or damage caused by non- compliance with these instructions. Keep these instructions in a safe place and pass them on to any...
This cooktop is not suitable for outdoor use. It is intended only to cook food and keep it warm. Any other use is not supported by Miele and could be dangerous. This cooktop is not intended for use by people (including children)
Warning and Safety instructions Safety with children Young children must not be allowed to use this appliance. Older children may only use the appliance if its operation has been clearly explained to them and they are able to use it safely. They must be aware of the potential dangers caused by incorrect operation.
Unauthorised installation, maintenance and repairs (including removal of any cover) can cause considerable danger for the user. Installation, maintenance and repairs must only be carried out by a Miele authorised technician. Damage to the cooktop can compromise your safety. Check the appliance for visible signs of damage.
If the mains connection cable is damaged, it must be replaced with a special mains connection cable, available from Miele, by a Miele authorised service technician or suitably qualified and competent electrician in order to avoid a hazard (see “Installation - Electrical connection”).
Disconnect it from the mains electricity and gas supply. Contact Miele. If the cooktop is installed behind a furniture door, do not close the door while the cooktop is in operation.
Warning and Safety instructions Correct use The cooktop gets hot when in use and remains hot for a while after being switched off. There is a danger of burning until the residual heat indicators go out. DO NOT USE THIS APPLIANCE AS A SPACE HEATER. ...
Warning and Safety instructions When the appliance is switched on either deliberately or by mistake, or when there is residual heat present, there is the risk of any metal items placed on the cooktop (e.g. cutlery) heating up. Depending on the material, other items left on the appliance could also melt or catch fire.
If the pan diameter is too large, flames can spread out to the sides and damage or burn the worktop, wall claddings or surrounding units and also parts of the cooktop. Miele cannot be held liable for this type of damage.
Warning and Safety instructions If the appliance has not been used for a long period of time it should be thoroughly cleaned before it is used again. It is also advisable to have the appliance tested by a qualified person for safety.
Caring for the environment Disposal of the packing Disposing of your old material appliance The transport and protective packaging Electrical and electronic appliances has been selected from materials which often contain valuable materials. They are environmentally friendly for also contain specific materials, disposal, and can normally be recycled.
Overview Cooktop KM 3034 a Rapid burner i Easy switch-off function b Auxiliary burner j Cooking zone symbol c Wok burner Controls knobs for the cooking zones: d Semi-rapid burner k Front right e Semi-rapid burner l Rear right f Pan support (separate for each...
Overview KM 3054 a Wok burner n Minute minder controls / indicators b Rapid burner o Easy switch-off function c Auxiliary burner Controls knobs for the cooking zones: d Semi-rapid burner g Front right e Semi-rapid burner h Rear right f Pan support (separate for each i Rear middle burner)
Overview Control knobs Auxiliary, semi-rapid and rapid burners Symbol Description Burner off, the gas supply is turned off Strongest flame Weakest flame Wok burner Symbol Description Burner off, the gas supply is turned off Largest flame: Inner and outer burner at highest setting. ...
Overview Auxiliary, semi-rapid and rapid Burner burners Wok burner a Burner cap b Burner head c Burner base d Ignition safety device a Outer burner cap e Ignitor b Inner burner cap c Burner head d Burner base e Ignition safety device f Ignitor...
Overview Minute minder controls / indicators a Activate system lock / Set the time b Minute minder - For switching on and off - For switching between functions - For selecting a cooking zone Indicator lights c Minute minder d Indicator light for relevant zone, e.g. the rear right cooking zone f In half hours if the minute minder setting exceeds 99 minutes e Time display ...
Overview Accessories supplied The accessories supplied with your appliance, as well as a range of optional ones, are available to order from Miele (see “Optional accessories”). Wok ring The wok ring supplied gives additional stability to the wok, especially to woks with a rounded base.
Before using for the first time Please stick the extra data plate for Switching on the cooktop for the appliance supplied with this the first time documentation in the space provided The metal components have a in the “Service” section of this protective coating which when heated booklet.
Suitable cookware – Unlike pans that are used on an Minimum pan base diameter electric cooktop, the bottom of pans Ø cm Burner used on a gas cooktop do not have to be flat to deliver good cooking Auxiliary burner results. Semi-rapid burner –...
Suitable cookware Wok ring Combination trivet Use the wok ring supplied to give The combination trivet must be used if additional stability to pans, especially you wish to use a pot or pan with a to woks with a rounded base. smaller diameter base than the minimum given in the table.
Tips on saving energy – Use a pan lid whenever possible to minimise heat loss. – Wide, shallow pans are preferable to tall, narrow ones. They will heat up faster. – Cook with as little water as possible. – Reduce the power setting once the water has come to the boil or the oil is hot enough to fry in.
Operation Rapid ignition system Switching on The appliance is supplied with a rapid Risk of fire with overheated food! ignition system with the following Unattended food can overheat and features: ignite. – Rapid ignition without the need to Do not leave the cooktop unattended press and hold the control knob.
Operation Adjusting the flame Switching off Turn the control knob clockwise to The burners can be regulated at any the position. level between the strongest and weakest flame. This stops the flow of gas and extinguishes the flame. As the outer part of the flame is much hotter than the centre, the tips of the Easy switch-off function flames should stay beneath the pan...
Operation In-operation / Residual heat indicators The in-operation / residual heat indicators light up when a cooking zone is ignited. They go out when the cooktop is switched off. If a cooking zone is hot, the indicator will light up as long as residual heat it still present.
Minute minder Setting the minute minder for a A duration of between 1 minute () cooking zone and 6 hours (.) can be set. A minute minder can be allocated for Use the - sensor to reduce the time any switched on cooking zone. This from ....
Safety features System lock Flame failure monitor The cooktop is equipped with a flame The system lock is deactivated if failure monitor. If a gas flame is there is an interruption to the power extinguished, e.g. by food boiling over supply.
Cleaning and care Unsuitable cleaning agents Risk of burning due to hot surfaces. To avoid damaging the surfaces of the The cooktop surface, pan supports appliance, do not use: and burners will be hot after use. – cleaning agents containing soda, Allow the cooktop to cool down alkalines, ammonia, acids or before cleaning it.
Remove any coarse soiling with a damp cloth and more stubborn soiling with a glass scraper. Then clean the ceramic glass surface with the Miele ceramic and stainless steel cooktop cleaner (see “Optional accessories”) or with a proprietary ceramic glass cleaner applied with a paper towel or a clean cloth.
Cleaning and care Pan supports Burner Remove the pan supports. Do not clean any parts of the burners in a dishwasher. Clean the pan supports in the dishwasher or with a solution of warm The surface of the burner caps will water and a little washing-up liquid become more matt over time.
Cleaning and care Assembling the auxiliary, semi-rapid The surface of the burner caps will and rapid burners become more matt over time. This is normal and does not indicate damage to the burner caps. Nor will it affect the operation of the cooktop. ...
Cleaning and care Assembling the wok burner Place the burner head on the burner base so that the ignition safety device and the ignitor extend through their respective holes in the burner head. The burner head must click into place correctly. ...
With the help of the following guide, minor faults in the performance of the appliance, some of which may result from incorrect operation, can be remedied without contacting Miele. This will save you time and money because you won't need a service call.
The ignitor on the The mains circuit breaker has tripped. burner does not spark. If it has, contact a qualified electrician or Miele. There is food residue stuck between the ignitor and the burner cap. The flame failure device is dirty.
Reset: Touch the easy switch-off function sensor for three seconds. If this fault message continues to appear in the display, contact Miele. All other faults There is a fault with the electronics. Interrupt the power supply to the cooktop for approx.
Miele online shop. Removes heavy soiling, limescale deposits and aluminium residues. They can also be ordered directly from Miele (see end of this booklet for Original Miele all purpose contact details). microfibre cloth Removes finger marks and light soiling.
Service Contact in case of fault In the event of any faults which you cannot remedy yourself, please contact Miele. Contact information for Miele can be found at the end of this booklet. Please quote the model and serial number of your appliance when contacting Miele.
*INSTALLATION* Installation Safety instructions for installation Damage from falling objects. Take care not to damage the cooktop when fitting wall units or a rangehood above it. Fit the wall units and the rangehood before the cooktop. The veneer or laminate coatings of worktops (or adjacent kitchen units) must be treated with 100 °C heat-resistant adhesive which will not dissolve or distort.
*INSTALLATION* Installation Safety distances Safety distance above the cooktop A minimum safety distance must be maintained between the cooktop and the rangehood above it. See the rangehood manufacturer's operating and installation instructions for details. If the manufacturer's instructions are not available for the rangehood, a minimum safety distance as per AS/ NZS 5601.1 must be maintained.
*INSTALLATION* Installation Safety distances to the sides and back of the appliance Ideally the appliance should be installed with plenty of space on either side. There may be a wall at the rear and a tall unit or wall on one side (right or left). On the other side, however, no tall unit or wall should stand higher than the appliance.
*INSTALLATION* Installation Clearance underneath the appliance A gas appliance shall be installed such that the surface temperature of any A minimum safety clearance of 15 mm nearby combustible surface* will not must be provided underneath the exceed 65 °C above ambient. appliance. The minimum clearance from a Please note that clearance must also be combustible surface shall be a 200 mm...
*INSTALLATION* Installation Detailed dimensions Height of pan supports above the worktop surface a Vertical distance b Worktop surface c Pan support The vertical distance from the top of the pan supports to the surface of the worktop is 57 mm. Distances from burner to the edge of the appliance KM 3034...
*INSTALLATION* Installation Tiled worktop Installation notes Seal between the cooktop and the worktop Grout lines and the hatched area underneath the cooktop frame must be smooth and even. If they are not, the cooktop will not sit flush with the worktop and the sealing strip ...
*INSTALLATION* Installation Installing the cooktop Installation Attach the sealing strip provided Preparing the worktop underneath the edge of the cooktop. Create the worktop cut-out as shown Feed the mains connection cable in the cooktop diagram. Remember down through the worktop cut-out. to maintain the minimum safety distances (see “Installation –...
*INSTALLATION* Installation Securing the cooktop Checking operation After installing the cooktop, ignite all burners to check that they are operating correctly: – The flame must not go out on the lowest setting, or when the control is turned quickly from the highest to the lowest setting.
*INSTALLATION* Installation Gas connection Check with your local gas supplier about the type of gas supplied and Risk of explosion due to an compare this information with the incorrect gas connection. type of gas quoted on the If the gas connection is carried out appliance's data plate.
Miele. Conversion to another type of gas is described in the section Connect the cooktop to the gas “Conversion to another type of gas”.
*INSTALLATION* Installation Setting the gas pressure For natural gas models The gas pressure must be set by the The gas regulator is only included with authorised gas fitter as shown on the appliances which are set up for data plate: connection to natural gas.
30 mA. accessible after installation. Replacing the mains connection Danger of injury! cable Miele cannot be held liable for unauthorised installation, Danger of electric shock! maintenance and repair work as this Incorrect connection to the electricity can be dangerous to users.
*INSTALLATION* Conversion to another type of gas Changing the jets Risk of explosion due to an incorrect conversion. Disconnect the cooktop from the If the conversion to another type of electricity supply and turn off the gas gas is carried out incorrectly, it may supply.
*INSTALLATION* Conversion to another type of gas Wok burner Changing the small jets To change the jets, the burner fixing screws must first be loosened and the upper section of the appliance removed. Pull the control knobs off. Remove the burner components. ...
*INSTALLATION* Conversion to another type of gas Secure the jets against inadvertent Checking operation loosening with sealing wax. Check all gas fittings for leaks. Reassemble the cooktop. Ignite all burners to check that they are operating correctly. –...
Miele Experience Centre South Melbourne: Auckland: 206-210 Coventry Street 8 College Hill South Melbourne, VIC 3205 Freemans Bay, Auckland 1011 Miele Experience Centre and Office Sydney: Miele Experience Centre Wellington: 3 Skyline Place Frenchs Forest, NSW 2086 183 Featherston Street...
KM 3034 / KM 3054 en-AU, NZ M.-Nr. 09 317 810 / 08...