Maintenance And Care; Transportation - Festool KAPEX KSC 60 EB Original Instructions Manual

► To deactivate the groove depth limit, reset
the lever [1-5].

10 Maintenance and care

WARNING
Risk of injury, electric shock
► Remove both battery packs from the power
tool before performing any work on the
power tool.
► All maintenance and repair work which re­
quires the motor housing to be opened
should always be carried out by an author­
ised service workshop.
Customer service and repairs must
only be carried out by the manufac­
turer or service workshops. Find the
nearest address at:
www.festool.co.uk/service
Always use original Festool spare
EKAT
4
parts. Order no. at:
www.festool.co.uk/service
5
3
2
1
Observe the following instructions:
► Damaged safety devices and components
must be repaired or replaced in a recog­
nised specialist workshop, unless otherwise
indicated in the operating instructions.
► Use an extractor on all openings of the pow­
er tool to remove wood chips and splinters.
Sawing chips and small parts that get
caught up in the sawing channel can be
gently pulled out through the open­
ing [13-4].
► To ensure constant air circulation, always
keep the cooling air openings in the housing
clean and free of blockages.
► Keep the contacts on the power tool, charg­
er and battery pack clean.
► When working with plaster- and cement-
bonded fibreboards, clean the tool particu­
larly thoroughly. Clean the vents of the
power tool and on/off switch using dry, oil-
free compressed air. Otherwise, gypsum
dust deposits may build up inside the power
tool's housing and on the on/off switch and
harden when exposed to humidity. This may
impair the switching mechanism
Cleaning the machine regularly, espe­
cially the adjusting devices and guides, is
an important safety factor.
10.1 Replacing the chip deflector [13]
To ensure that dust and chips are collec­
ted properly, you must only work if a chip
deflector is installed.
► Undo the screws [13-1] on the guard, re­
move the chip deflector and clamp.
► Attach the clamp [13-2] to the new chip de­
flector.
► Screw the chip deflector [13-3], along with
the clamp, onto the guard.
10.2 Replacing the table top insert [14]
Always replace worn table top inserts. Never
use the machine without table top inserts.
► Unscrew the position marking [14-3] for the
bevel.
► Undo the screws [14-1] in the table top in­
sert.
► Replace the table top insert [14-2] and po­
sition marking [14-3].
► Reattach the screws.
► Check that the position markings
on a line that, at the same time, must run at
a right angle to the stop rulers.
10.3 Cleaning/replacing the spotlight
window
The spot lighting lights up the cutting edge on
the workpiece. Dust-intensive work may affect
the power of the light. Proceed as follows to
clean the spotlight [15]:
► Move the machine into the working position.
► Pull out the spotlight window [15-1] by
hand, and clean/replace it.
► Reinsert the spotlight window.
The spotlight window audibly clicks into
place.

11 Transportation

CAUTION
Risk of crushing
The saw unit may swing out/extend
► The machine must always be transported
in the transport position that has been pro­
vided for this purpose.
English
lie
35