Care And Maintenance - Trane MCXE Series Owner's Manual & Installation Manual

Care and Maintenance

Indoor Unit and Air Filter Cleaning
1. Push latch at air inlet grille and insert a screwdriver to remove screw.
2. Detach the grille from the main unit by holding the grille at a 90° angle, lifting it up slightly.
3. Pull out the air filter to clean.
4. Clean the air filter by vacuuming the surface or washing it in warm water with mild detergent.
5. Rinse the filter with clean water and allow it to air-dry. DO NOT let the filter dry in direct sunlight.
6. Reinstall the filter.
CAUTION
• Before changing the filter or cleaning, turn off the unit and disconnect its power supply.
• When removing filter, do not touch metal parts in the unit. The sharp metal edges can cut you.
• Do not use water to clean the inside of the indoor unit. This can destroy insulation and cause electrical shock.
• Do not expose filter to direct sunlight when drying. This can shrink the filter.
• Do not use chemicals or chemically treated cloths to clean the unit.
• Do not use benzene, paint thinner, polishing powder or other solvents to clean the unit. They can cause the
plastic surface to crack or deform.
• Do not use water hotter than 40°C (104°F) to clean the front panel. This can cause the panel to deform or
become discolored.
• Only use a soft, dry cloth to wipe the unit clean. If the unit is especially dirty, you can use a cloth soaked in
warm water to wipe it clean.
Outdoor Unit Cleaning
• Any maintenance and cleaning of outdoor unit should be performed by an authorized dealer or a licensed service provider.
• Any unit repairs should be performed by an authorized dealer or a licensed service provider.
44
If using water, the inlet side should
face down and away from the water
stream.
If using a vacuum cleaner, the inlet
side should face the vacuum.
MCXE-IOM