Software Problems; Sound Problems - Getac S410 Series User Manual

The computer does not enter Sleep or Hibernation mode
immediately.
If the computer is performing an operation, it normally waits for the

operation to finish.
The computer does not resume from Sleep or Hibernation mode.
The computer automatically enters Sleep or Hibernation mode when the

battery pack is empty. Do any one of the following:
−
Connect the AC adapter to the computer.
−
Replace the empty battery pack with a fully charged one.

Software Problems

An application program does not work correctly.
Make sure that the software is correctly installed.

If an error message appears on the screen, consult the software

program's documentation for further information.
If you are sure the operation has stop, reset the computer.


Sound Problems

No sound is produced.
Make sure that the volume control is not set too low.

Make sure that the computer is not in Sleep mode.

If using an external speaker, make sure that the speaker is properly

connected.
Distorted sound is produced.
Make sure that the volume control is not set too high or too low. In

most cases, a high setting can cause the audio electronics to distort the
sound.
The sound system does not record.
Adjust the playback or recording sound levels.

53