Troubleshooting - Magio MG-324 Manual

4. Disconnect the steam hose and drain the remaining water from the vent hole.
5. Never immerse the unit into water!
6. Avoid moisture getting into parts of this appliance.
7. Never use sharp or abrasive to clean the appliance.
1. Remove the hose and telescopic tube.
2. Add citric acid to pure water at a ratio of 1:5.
3. Fill the mix with the water tank.
4. Turn on the device. In 20 minutes work off the device.
5. Wait 10 minutes, then drain the water from the tank.
6. Fill the tank with clean water and repeat the above point 2-3 times.
1. Unplug the unit.
2. Clean the unit before taking the unit for storage.
3. Empty and allow to drying out the water tank.
4. Wind the power cord.
5. Keep the unit in a dry cool place out of reach of children and disabled persons.
6. Always keep the iron in an upright position.
PROBLEM
Unit fails to • Steamer is not
steam plugged in
• The water tank
is empty
Weak • Mineral deposit
steaming in the unit
• The water tank
is empty
Water flows • Condensation
through the has accumulated
spray pairs in the steam hose
The steam is • Mineral deposit
slowly in the unit
warming up
ENGLISH: ENGLISH:
REMOVAL OF SCIENCE

TROUBLESHOOTING

REASON
• Make sure the device is properly connected to the power
supply, and the power button is in the on position.
• Make sure the steam hose is not bent or refracted.
• Switch off the device, allow it to cool for at least 5
minutes, and pour water into the tank.
• Clean the steamer from scum at least once a year or every
50 hours of operation. If you use hard water, you should
clean the device more often.
• Switch off the device, allow it to cool for at least 5
minutes, and pour water into the tank.
• Never use the steamer in a horizontal position. Hold the
steam hose vertically in the stretched position until the
water drains back into the steamer.
• Clean the steamer from scum at least once a year or every
50 hours of operation. If you use hard water, you should
clean the device more often.
STORAGE
SOLUTION