Kia EV6 Manual page 20

Electric vehicle guide
僅 Do not put metal objects to the V2L
connector or charging hole. It might
be a cause of electric shock.
僅 Do not touch the V2L connector,
charging hole or power plug with a
wet hand. It might be a cause of elec-
tric shock. Please handle with a dry
hand all the time.
僅 Confirm whether there is foreign sub-
stance such as water or dust on the
V2L connector, charging hole or
power plug before connecting. If you
connect it with foreign substances, it
may be a cause of fire or electric
shock.
僅 Do not remodel or disassemble the
V2L connector. There is a risk of fire,
electric shock or injury.
僅 When the power plug is connected or
disconnected to the V2L connector or
open or close the connector cover of
the V2L, be careful not to be
scratched on the hand.
僅 Do not charge in the following condi-
tions. The accident might occur.
- The V2L connector, charging hole,
power plug or cable is damaged,
corroded or rusted.
- The connection part is loose.
僅 Do not use if the sheath of home
appliance cables is damaged or bro-
ken. There is a risk of fire, electric
shock or injury.
僅 Never use an electric heating appli-
ance like iron, coffee pot, and toaster
in the vehicle. It may cause a fire and
injury.
CAUTION
僅 Be well-informed of the manual to
prevent accidents.
2 12
僅 The V2L discharging mode is blocked
automatically in case of overheating.
(When the discharging mode is
blocked, check whether the V2L con-
nector or power plug is contaminated,
worn, corroded or broken or the home
appliance capacity is over 16 A. If the
temperature falls to proper level after
it is left unattended, you can use it
again. Use proper home appliances.)
僅 Do not remodel or disassemble the
provided V2L connector. The failure
caused by remodeling or disassem-
bling is not covered by the warrant.
僅 Do not drop the V2L connector or give
a strong impact to it.
僅 Do not place objects on the V2L con-
nector.
僅 Be sure to disconnect the V2L connec-
tor from the vehicle when you are fin-
ished using V2L.
僅 When the high voltage battery charge
reaches the set discharging limit(%),
the operation stops, and a warning
message is displayed on the
instrument cluster. If you want V2L
operation, set the discharging limit(%)
lower than the current battery charge.
僅 When using various electric products,
use them below the maximum power
capacity that can be supplied by the
vehicle.
僅 If you use an electrical appliance that
exceeds the maximum power capac-
ity that the vehicle can supply, the
operation will stop and a warning
message will be displayed on the
instrument cluster. Make sure the
total power consumption of the elec-
trical appliance you use does not
exceed the V2L maximum power
capacity.
EV menu