Control Functions; Control Panel - Jacuzzi J - 200 J - 230 Owner's Manual

J-200
9.0

Control Functions

9.1

Control panel

A. leD Display: Can
display current water
temperature (de-
fault display), water
temperature set point,
selected filtration/
heating mode, and
error messages.
B. Heat Indicator: Lit when heater is on.
C. Jets 1 Button: Turns jets pump #1 on and off. Press once for low
speed; press a second time for high speed; press a third time to turn
pump off.
D. Jets 2 Button: Turns high-speed jets pump #2 on and off. Press
once to turn pump #2 on; press a second time to turn pump #2 off.
E. light Button options:
• With standard incandescent light: Turns underwater light on and off.
• With optional LED lighting system: Turns underwater light and top
rim accent lights on in one of three random modes or one of seven
solid colors. Refer to Section 10.4 (page 27) for details.
F. warmer (
G. Cooler ( ) Button: Decreases water temperature set point.
operation Details
• Temperature Adjustment: 65 to 104°F (18 to 40°C). Factory default
setting is 100°F (38°C).
• Standard light system: Incandescent light runs for 1 hour, then
automatically shuts off for increased bulb life.
• Optional LED light system: All LED lights run for 1 hour, then
automatically shut off.
• Jets 1/Jets 2 Button Operation: Jets run for 20 minutes when
activated, then turn off automatically to conserve energy. Simply
press either jets button to continue operation for an additional 20
minutes.
24
) Button: Increases water temperature set point.
C
D
1
E
2
A
B
G
F