On/Off Switch; Ignition Module; Voltage Regulator - L.B. White PALS Owner's Manual And Instructions

1. Disconnect the electrical leads from the On/Off switch.
2. Remove the rubber boot from the On/Off switch. See
Fig. 6.
3. Remove the switch from the control box.
1. Disconnect all electrical leads from the ignition
control, including igniton cable and flame sensor..
2. Remove the screws securing the ignition control
module to the control box back.
ATTENTION
Handle the voltage regulator at the edges of the board.
Do not touch voltage regulator components. Doing so
may damage the voltage regulator.
1. Disconnect electrical leads from the voltage regulator.
2. Remove nuts which secure voltage regulator to control
box.
FIG. 6
FIG. 7
FLAME SENSOR
CONNECTION
FIG. 8
IGNITION
CONTROL

ON/OFF SWITCH

BOOT
SWITCH

IGNITION MODULE

IGNITION CONTROL
IGNITION LEAD

VOLTAGE REGULATOR

VOLTAGE
REGULATOR
NUT
12