Advertisement
3. INSTALL TANK & TOILET SEAT
• Install Toilet Seat #10570 onto Tank #22918, using plastic bolts and nuts provided
with seat.
• Place Tank #22918 into Base cradle.
• Push Tank firmly down, see that tank is level, and fasten using (6) Screws #13860 (2
screws in
each panel at dimple location in panels as shown) using 3/8" HEX NUT DRIVER BIT,
NOTE: DIMPLE LOCATION IN REAR PANEL IS DIFFERENT FROM SIDE PANELS.
8
6
4. INSTALL URINAL
• Drill at dimple location on inside of left panel using 1/4 DRILL BIT.
• Install Urinal #23828 drain tube into hole in top of tank front left corner.
•
Rivet top of urinal to panel using rivet #22543 outside on panel and washer #11315 inside
on urinal.
• Transfer drill through side tab on urinal through panel.
• Rivet side tab to panel using rivet #22543 outside on panel and washer #11315 inside on
tab of urinal.
15
(2)
Dimple in left panel
10-5-21
REV A
DO NOT OVER TIGHTEN SCREWS
7
24048 INSTRUCTION- ASPEN II
Back panel
11
(6)
17
(2)
7
Advertisement
