Satellite portable restrooms must be assembled according to approved assembly procedures.
Avoid variations in assembly procedures which could adversely affect product life and warranty.
IMPORTANT: Do not remove shipping screws / shipping strap from bottom door until instructed to in the
"Install the Front Assembly" step.
TOOLS:
*DRILL CORDLESS
*3/8" HEX DRIVER BIT
*#10 or (3/16") DRILL BIT
*1/4 DRILL BIT
*RIVET GUN
*#2 PHILLIPS DRIVER BIT or SCREWDRIVER
*7/16" HEX NUT DRIVER BIT
HELPFUL HINTS:
• KEEP WORK AREA ORGANIZED.
• Do not open all of the kit boxes, only enough to assemble the toilets you are currently working on.
• Use toilet paper holders for parts bins on multiple unit assembly
• The door latch can be put on at any time. For efficiency this can be done earlier on multiple unit
assembly.
• The assembly procedure is written for assembly of a single unit. If assembling multiple units,
considerable efficiency can be gained by having a crew work in assembly line fashion.
• An apron with large pockets, is handy for holding parts and tools.
All references to left, right, front and rear correspond to this illustration.
10-5-21
REV A
INTRODUCTION
LEFT
FRONT
24048 INSTRUCTION- ASPEN II
REAR
RIGHT
2