Adjusting The Coff Ee Length - Gaggia Unica Operating Instructions Manual

using a key. Do not pour cof ee beans
when the cof ee grinder is working.
The machine lets you make slight adjust-
ments to the cof ee grinder to adapt it to
the kind of cof ee used.
This adjustment should be carried out by
adjusting the pin on the inside of the cof-
fee bean hopper; this pin must be pressed
and turned only with the key provided
with the cof ee machine.
Press and turn the pin one notch at a time
and brew 2-3 cups of coffee; this is the
only way to notice dif erences in grind.
The reference marks inside the coffee
bean hopper indicate the grind setting.
There are 5 different grind settings to
choose from with the following refer-
ences:
2
1
1 - Coarse Grind
2 - Fine Grind
Adjusting the Coff ee Length
The machine allows you to adjust the
amount of brewed coffee according to
your taste and/or the size of your cups.
Each time the "
pressed and released, the machine brews
a pre-set amount of coffee, as per fac-
tory settings. This amount may be repro-
grammed to your taste. Each button may
be individually programmed for a specii c
brew setting.
As an example, the following procedure
describes the programming of the "
button, which is normally associated with
espresso cof ee.
• Place a cup under the dispensing
spout.
• Hold the "
seconds to enter the programming
mode; the "
and the cof ee will start to be brewed;
the icon will flash during the whole
cof ee brewing cycle.
" or " " buttons are
"
" button pressed for 5
" icon will blink quickly
• Press the "
amount of coffee in the cup reaches
the desired level.
Blinking
At this point, the "
quickly
grammed; each time it is pressed and
released, the machine will brew the same
amount of cof ee that has just been pro-
grammed.
The same operation can be repeated for
the " " button. When the "
button is pressed twice to brew coffee,
the machine will brew double the stored
quantity.
OFF-Mode
The machine is designed for energy sav-
ing. The machine automatically turns of
after 60 minutes of inactivity.
Note: During the turning of
phase, the machine performs
a rinse cycle, if a cof ee product has
been brewed.
Warning: When the power cord is in-
serted, the machine is in OFF-Mode.
To turn the machine on again simply press
the ON/OFF button; in this case the ma-
chine will go through the rinse cycle only
if the boiler is cold.
" button again when the
" button is pro-
" or " "
• 31 •