Parameter Setting Page - Expert EX9132C-2-MTCP Operation Manual


Password
This field is the administration password for authentication. Factory default is "empty". However, it is not
recommended to leave it empty in field operation. If you could not login, it means you have to key in the
password. If you do not know the password you can reset the EX9132C-2-MTCP (First, turn on the power.
Second, use any point tip to push this button and hold it about 3 seconds All the parameters will be reset to the
factory default. But do not over 5 seconds, it will enter update mode.
Converter device uses the same password protection mechanism commonly used in Windows NT or UNIX. If
there are more than "3 consecutive failures" in password check during login, the login function will be disabled
for "15 minutes". During this 15 minutes period, even if you supply correct password, login will not proceed.
This prevents intruders from finding the password by computer generated program.

3.7 Parameter Setting Page


The Parameter Setting Page
Type the correct password in the "Password" field and click the "Confirm" button in the "Login Setting" page,
then the "Parameter Setting" page will be shown
Note: If you forget the password or can't login successfully, please contact the manufacturer directly.
Page 16 EX9132C-2 • Manual Version 1.1 • 21.09.2015
EX9132C-2-MTCP
Manual
www.expertdaq.com