Case 2: Change Settings With Brc301B61; Case 3: Change Settings With Brc1H; Field Settings - Daikin VAM-J8 Installation And Operation Manual

Field Settings

Save the settings?
Yes No
Return Setting
11 After you have completed all changes, press the Cancel button
(a) twice to return to the normal mode.

Case 2: Change settings with BRC301B61

Make sure that the switch box lid on the heat reclaim ventilation unit
is closed.
1 With the unit in normal mode, press the Inspection/Trial button
(a) for more than 4 seconds to enter the local setting mode.
2 Use the Ventilation mode button (up - b) and the Airflow rate
button (down - b) to select a mode number.
Result: The code display is blinking.
3 To configure settings for individual units under group control,
press the Timer setting on/off button (c) and select the number
of the unit that you want to configure.
4 To select the setting switch number, press the top section of the
Timer button (d). To select the setting position number, press
the lower section of the Timer button (e).
5 Press the Program/Cancel button (f) once to enter the setting.
Result: The code display stops blinking and lights up.
6 Press the Inspection/Trial button (a) to return to normal mode.
VAM350~2000J8VEB
Heat reclaim ventilation unit
4P664011-1 – 2021.08
c
f
a
d e
b
INFORMATION
Setting 18(28)-11 CANNOT be selected with this controller.
a

Case 3: Change settings with BRC1H

INFORMATION
Please refer to the Installer and user reference guide of the
BRC1H user interface.
13 Configuration
SETTING
b
Installation and operation manual
19