Removal Of Led Board; Removal Of Led Board; Removal Of Back-Tally Base; Removal Of Back-Tally Base - Panasonic AJ-HVF20P Service Manual

11. Removal of LED Board

1. Disconnect the connector (A) on Indicate plate.
2. Unscrew 4 screws (J) so that the CRT Assembly
can be removed.
SCREW
(J)
CONNECTOR (A)
3. Unscrew 4 screws (K) so that the LED Board can
be removed.
SCREW
(K)

12. Removal of Back-tally Base

1. Unscrew 2 screws (L) so that the Back-tally base
can be removed.
SCREWS (L)
NOTE: If "GASKET" installed behind of the Back-tally
base unit is deteriorated, replace "GASKET".
NOTE: For assembling the parts, take opposite steps
of each disassemble procedure.
MEMO
SCREW
(J)
SCREW
(K)