Table of Contents
Advertisement
Setup
Part names and
functions
M
Used to register the backup
battery to the hub.
LED indicator
Power supply plug
DC jack
LED indicator
You can use the LED indicator to
confirm the backup battery's status.
Indicator
Green, lit
Green,
blinking
Red, blinking
slowly
Red, blinking
Amber, lit
Amber,
blinking
Off
8
Shinsei_HNP100_(en_us)_0420_ver.000.pdf
N
Status
Normal operation
(when charging is
fully complete)
Registration mode
(you pressed and
held M
N)
Backup battery is
not registered to a
hub
Backup battery is
out of range of the
hub
*1
Battery charging
Power failure
detected
Low battery
For assistance, please visit www.panasonic.com/support
8
*1
The LED indicator does not
indicate sensor status if the
backup battery has not been
registered (page 10).
Note:
R When the battery operating time
seems to be shorter, even after I
fully charged the battery:
– Clean the battery ends (
and the charge contacts with a
dry cloth and charge again.
– It is time to replace the battery.
Backup battery
performance (when
using the supplied
battery)
The backup battery can provide power
to your Home Network System devices
(one device per backup battery),
allowing your devices to continue to
operate in the event of a power failure.
Compatible
Operating time
devices
*1
HUB
Approx. 1.5 hours
(KX-HNB600)
(standby, connected
to 4 cameras, not
connected to a
Wi-Fi network)
Indoor
Approx. 1.8 hours
Camera
(standby, night view
(KX-HNC200)
mode)
Outdoor
Approx. 1.6 hours
Camera
(standby, night view
(KX-HNC600)
mode)
Indoor Siren
Approx. 8 hours
(KX-HNS105)
(standby)
,
)
2015/04/20
11:39:45
Advertisement
Table of Contents
