Assembling The Reflected Light Light Source; Assembling The Led10 Light Source For Reflected Light Illumination; Assembling The Hal 100 Light Source For Reflected Light Illumination; Assembling The Adjustment Tool Of Hbo 100 - Zeiss Axioscope 5 Instruction Manual

ZEISS

4.12 Assembling the Reflected Light Light Source

4.12.1 Assembling the LED10 Light Source for Reflected Light Illumination

For assembling the LED10 light source for reflected light illumination, proceed in the same way as
for the LED10 light source for transmitted light illumination [

4.12.2 Assembling the HAL 100 Light Source for Reflected Light Illumination

For assembling the HAL 100 light source for reflected light illumination, proceed in the same way
as transmitted light illumination [

4.12.3 Assembling the Adjustment Tool of HBO 100

This procedure applies to the following stand type only:
§
Fig. 47: Assembling the adjustment tool
1
3
Prerequisite
ü
ü
Procedure
1. Remove the cover cap
2. Insert the adjustment tool
3. Tighten the three included screws
4. Attach the cover cap with opening
5. Slide in the movable connecting piece of the adjustment tool.
Proceed in the reverse order for removal.
Instruction Manual ZEISS Axioscope 5, Axioscope 5/7 MAT | en-US | Rev. 13 | 430035-7344-001
Axioscope 5 Bio-TL/RL
Cover cap
Adjustment tool
The microscope is switched off.
The HBO 100 light source is installed.
4 Installation | 4.12 Assembling the Reflected Light Light Source
}
75].
1
2
3
4
2
4
1
from the mounting aperture of the stand.
3
.
2
.
4
to the mounting aperture. Make sure it locks.
}
74].
Screw (3x)
Cover cap with opening
77