Table of Contents
Advertisement
Deck Height Lift Lever
Located to the right and front of the operator, the lift
lever controls the cutting height. The deck cutting
height is obtained by pressing the foot pedal forward
to lift the deck. To lower the deck, apply pressure to
the top side of the foot pedal and allow it to pivot while
depressing the trigger and moving the lever forward.
Set the desired cut height with pin.
The cutting height range is from 1½" (38 mm) to 5½"
(140 mm) in ½" (13 mm) increments. The heights are
measured from the ground up to the blade tip with the
engine not running.
IMPORTANT INFORMATION
Always use the high position to transport.
IMPORTANT INFORMATION
In order to obtain an even cutting height it
is important that the air pressure in all four
tires is the same 15 psi (1 bar).
20
-
English
CONTROLS
3
4
1. Lift lever
2. Trigger
3. Set pin
4. Foot pedal
Cut height lift lever and pedal
1
2
8050-774
Advertisement
Table of Contents
