Table of Contents
Advertisement
3. Turn both outer blades to align with the deck in
front-to-rear manner. Reposition rear mounting
bolts up or down until rear of mower deck is
positioned level to
/
1
the side-to-side measurement.
4. Confirm measurements once again. Blade tips
should be level in a side-to-side manner. In the
rear, blade tips should be level to
than side-to-side measurement. In the front,
blade tips should be level to
side-to-side measurement.
NOTE: This will place the mower deck in
a base measurement position. Ad-
ditional adjustment may be required
to achieve desired cut for the type of
grass or conditions being mowed.
Nose Roller
Nose rollers are properly adjusted when they are
just slightly off of the ground when the deck is at the
desired cutting height in the operating position. Nose
rollers keep the deck in the proper position to help
prevent scalping in most terrain conditions.
•
Adjust the deck to the desired cutting
height (see "TO ADJUST DECK CUTTING
HEIGHT" in the operation section of this
manual).
•
Using a
/
" wrench, remove the nut and
9
16
shoulder bolt from the nose roller.
•
Lower the roller to the ground, and raise it
up to the next highest hole.
•
Replace and tighten the nut and shoulder
bolt.
Be sure to readjust the nose roller if the cutting height
is changed.
42
-
English
MAINTENANCE
" higher in the rear than
8
/
" higher
1
8
/
" lower than
1
8
2
1. Bolt
2. Nut
Nose roller
1
Advertisement
Table of Contents
