Table of Contents
Advertisement
Problem
"d" appears on the dis-
play and the oven does
not heat up in any mode.
If you are unable to remedy the problem
by following the above suggestions,
please contact your dealer or the Cus-
tomer Care Department.
Warning! Repairs to the appliance are
only to be carried out by qualified service
engineers. Considerable danger to the
user may result from improper repairs.
If the appliance has been wrongly oper-
ated, the visit from the customer service
Installation Instructions
Caution! The new appliance may only
be installed and connected by a
registered installation engineer. Please
comply with this instruction. If you do
not, any damage resulting is not covered
by the warranty.
To prevent future hazards, damaged mains
cables must only be replaced by a qualified
electrician.
Safety information for the installer
• The set-up of the electrical installation is
arranged so that the appliance can be iso-
lated from the mains with a minimum 3mm
all-pole contact separation.
Possible Cause
Test mode is switched on
Switch the appliance off, hold down
and
the signal sounds and the "d" on
the display goes out.
technician or dealer may not take place
free of charge, even during the warranty
period.
Advice on cookers with metal fronts: Be-
cause of the cold surface at the front of
the cooker, opening the oven door dur-
ing (or just after) baking or roasting may
cause the glass to steam up.
Suitable separation devices include e. g.
cut-outs, fuses (screw fuses are to be tak-
en out of the holder), RCD's and contac-
tors.
• The site must provide a connection to the
electrical supply by means of a socket that
is accessible and outside the coordination
space.
• Anti-shock protection must be provided by
the installation.
• The built-in unit must meet the stability re-
quirements of DIN 68930.
electrolux 31
Remedy
at the same time until
Advertisement
Table of Contents
