Panasonic WX-CC411BP Operating Instructions Manual page 38

Operating procedures
4
On the Settings screen, touch the [Wireless
Repeater] button, ([Lane A/B] button,)* and
then the [ID Registration] button.
* This appears only when the WX-CC412BP is used.
Note
p p If 2 Wireless Repeaters have already been registered
in the Center Module, the [ID Registration] button
cannot be touched.
First delete the ID of a Wireless Repeater, then do the
ID registration procedure again.
5
Touch the [Start] button.
p p The following pop-up screen is displayed. You cannot
perform other operations during ID registration. To
continue ID registration, touch the [YES] button. To
stop ID registration, touch the [NO] button.
p p Touch the [YES] button to start Wireless Repeater ID
registration mode.
38
WX-CC411BP_PUQX1028ZAV1_IG.indb 38
6
Press and hold the Wireless Repeater [ID REG]
button for 3 or more seconds.
p p The Wireless Repeater starts in ID registration
mode and the [STATUS] indicator blinks orange. The
Wireless Repeater searches for the Center Module in
the repeater ID registration mode.
p p The numbers of any registered Wireless Repeaters
are shown in the [Registered Wireless Repeaters]
field during registration. If ID registration succeeds,
the ID of the registered repeater is added.
p p If ID registration succeeds, the [STATUS] indicator on
the Wireless Repeater lights orange (or blinks orange
slowly) when registering to lane A. It lights green (or
blinks green slowly) when registering to lane B.
Note
p p You can continue to register until 2 Wireless Repeaters
are registered in the Center Module.
Touch the [Stop] button to exit the ID registration
mode.
p p To continue and register a 2nd Wireless Repeater,
perform step 6 on the other Wireless Repeater.
When registration of the 2nd unit for a single Center Module
is successfully completed, the following pop-up confirmation
screen is displayed, and the repeater ID registration mode
on the Center Module is automatically exited.
2022/03/07 11:26:42