Installation Precautions - Panasonic WX-CC411BP Operating Instructions Manual

Precautions
w Installation precautions
p
WARNING:
In order to safeguard against injury, this
device must be mounted on a wall, following the steps in
the Operating Instructions.
Panasonic assumes no responsibility for injuries or
property damage resulting from failures arising out of
improper installation or operation inconsistent with this
documentation.
Avoid installing in the following locations.
p p Locations exposed to direct sunlight
p p Locations subject to having strong vibration or impact
p p Locations which are not level
p p Locations under the air conditioner
p p Locations near the fryer
p p Locations near the grill
p p Locations where a chemical agent is used such as a
swimming pool
p p Locations near magnetic field sources such as a
television or speakers
p p Locations where condensation forms easily, where
temperature changes greatly, humid places
p p Locations subject to dust
p p Locations subject to water splash or spray
p p Locations where radiation or x-ray emissions are
produced
The accessory power cord is to be used only with this
unit.
Do not use it for any other devices. Similarly, do not use the
power cords of other devices with this unit.
Grounding
Confirm that the wire is connected from the SIGNAL GND
terminal to earth ground. A grounding connection must be
made before connecting the power plug or this product to
the main power supply. When disconnecting the grounding
wire, make sure that the power plug of this product is
disconnected from the main power supply.
Power supply used
The supply voltage of this unit is AC 100 V to 120 V
(50 Hz/60 Hz). Connect this unit to a power supply with a
sufficiently high capacity.
14
WX-CC411BP_PUQX1028ZAV1_IG.indb 14
To cut the power supply
This product has no power switch. To cut the power supply,
unplug the power plug of the product from the AC outlet. If
it is hard to unplug the power cord due to the installation
conditions, connect the power cord of the product to the AC
outlet via the circuit breaker of a distribution board or to the
AC inlet socket of a power supply control unit.
Be sure to connect the power cord via any of the following
breaking devices:
p p Connect the power cord via a power supply control unit.
p p Install the product near a power outlet, and connect the
power cord via the power plug.
p p Connect the power cord to the breaker with contact gap
of 3.0 mm or more of a distribution board. The breaker
shall be able to shut down all the poles of the main power
supply except the ground protective conductor.
Setting the time
Before operating this unit, you must set the time. For how
to set the time, refer to the Operating Instructions <Setup
Instructions>.
2022/03/07 11:26:31