Hunter 42775-01 Installation And Operation Manual page 7

For Low Profile mounting:
Note: For low profile mounting, the downrod is replaced with
the low profile washer.
3-5. Remove the set screw from the adapter.
3-6. Place the low profile washer (lip up) into the canopy. Be
sure the green ground wire is pointing up toward the
ceiling.
3-7. Align the holes in the washer with the holes in the adapter.
Assemble securely with three low profile screws.
3-8. Raise the fan and place the hook on the ceiling plate through
the U-shaped hole in the rim.
Optional Downrod Instructions:
Your Hunter fan comes with an optional downrod extension
pipe. If you would like to use the enclosed optional 6 inch
downrod, follow the steps below.
Note: The Perfect Balance
that are 6" and shorter. If you use a downrod longer than 6
inches, do not remove the red retaining screws.
3-9. Remove the pipe ball screw from the standard downrod,
then slide the ball off the pipe.
3-10. R emove the pin from the pipe, then slide the wedge off the
pipe.
3-11. Remove the screw and ground wire from the pipe.
3-12. R eassemble the ground wire, wedge, pin, ball, and pipe ball
screw, in that order, onto the long downrod.
3-13. Go back to Step 3-2.
3 • Assembling and Hanging the Fan
system is designed for downrods
TM
Low Profile Screw
42775-01 • 04/29/08 • Hunter Fan Company
Steps 3-5 – 3-6
Steps 3-9 – 3-12
Ground Wire
and Screw
Ball
7
Low Profile Washer
Step 3-7
U-shaped
Hole
Pipe Ball Screw
Pin
Wedge