Rapid Shape D50+ Translation Of The Original Operating Instructions page 89

Execution
Figure 31: Cleaning the hose
89 │ 96
Operating Instructions D50+ | P50+ | SHERAprint 50
For cleaning the hose, please proceed as follows:
1. Main menu: Press the «Manual Mode» button and then the
«Manual Refill» button.
2. Press and hold the «Pump Forward» button for the duration of
the pumping process (see figure below). The isopropanol is
pumped through the hose to clean the inside of the hose.
3. After approx. 60 seconds: Release the «Pump Forward» button
to stop the pumping process. Now press and hold the «Pump
Reverse» button to repeat the cleaning process (see figure
below). Release the button after approx. 30 seconds.
4. Then check whether the hose is sufficiently clean on the inside.
Repeat the process if any material remains visible inside the
hose.
Figure 32: Manual mode, "Manual Refill" overview
5. After completion of the cleaning process: Pull the left-hand end
of the hose out of the bottle of isopropanol. In doing so, wipe
the hose surface dry with a paper towel and then insert a piece
of paper towel into the hose opening to soak up any
isopropanol that drips out. Carefully hang the hose down
towards the floor.
6. Pull the right-hand end of the hose with the stainless-steel tube
out of the bottle of isopropanol. Wipe the hose surface dry as
well here with a paper towel and then insert a piece of paper
towel into the hose opening to soak up any isopropanol that
drips out. Then carefully hang the hose down towards the floor.
7. If available, use compressed air to clean the hose. To do so,
remove the paper towel from the left-hand end of the hose and
hold the paper towel at the right-hand end of the hose firmly in
place. Now blow the compressed air into the hose through the
free hose opening.
If no compressed air is available, let both ends of the hose hang
down towards the floor for some time so that any remaining
isopropanol can drip off.
8. After completion of the drying process: Lay the left-hand hose
along the holder guide so that the hose clamp at the upper end
of the hose (short stainless-steel spigot) is flush with the hose
holder.
9. Push the hose back into the holder guide and insert the hose
holder with the material feed hose into the refill printing position.
(Caution! Do not inhale the aerosol spray.)
Rapid Shape GmbH │ DOCR000438