Rapid Shape D50+ Translation Of The Original Operating Instructions page 87

87 │ 96
Operating Instructions D50+ | P50+ | SHERAprint 50
4. Place the reservoir on a clean and level surface.
5. Take a paper card and carefully slide one corner of the card
under the exposed layer of material at the bottom of the
reservoir. By doing so, hold the detached side of the material
layer with your thumb.
6. Now, slowly pull the layer off the bottom of the reservoir.
7. Allow any excess material to drip into the reservoir and then
place the removed layer on a paper towel. The bottom of the
reservoir is now clean.
8. Push the material reservoir back into the machine and close the
upper hood.
9. Dispose of the material layer as intended according to local
waste disposal regulations. We recommend to completely cure
the layer for disposal as plastic waste.
E NV IRO N MEN TA L P ROT E C TI ON !
Environmental hazard due to the incorrect disposal of
materials!
The incorrect disposal of printing materials can be
hazardous to the environment.
– Please dispose of all consumables as intended in
accordance with the local waste disposal
regulations. Please take note of the safety data
sheets of the respective materials.
Rapid Shape GmbH │ DOCR000438