Table of Contents
Advertisement
6-4-3. Prconf Command
This command shows the SNMP configurations.
Command format : prconf
Execution example
1. Enter "prconf".
The SNMP settings are displayed.
SNMPCmd>prconf
01 : Read Community = public
02 : Write Community = private
03 : Trap Community = public
04 : Trap Dest Address(1) = 0.0.0.0
05 : Trap Dest Address(2) = 0.0.0.0
06 : Trap Dest Address(3) = 0.0.0.0
07 : Timezone String = GMT+09:00
08 : POH Limit(hours) = 0
09 : Y Axis Count Limit = 0
10 : Z Axis Count Limit = 0
11 : T Axis Count Limit = 0
12 : Door Count Limit = 0
13 : Fan POH Limit(hours) = 0
01 : R/O parameter community
02 : R/W parameter community
03 : Trap community
04 : Trap send destination address (1)
05 : Trap send destination address (2)
06 : Trap send destination address (3)
07 : System time zone string
08 : Remaining hours until the next maintenance
09 : Maximum number of operations of the Y-axis of the elevator
10 : Maximum number of operations of the Z-axis of the elevator
11 : Maximum number of rotations of the bin drum
12 : Maximum number of door openings/closings
13 : Maximum power-on hours of the fan
* : When the system exceeds the set value, a warning can be issued from SNMP. The warning will
not be issued if the item is set to 0.
6-6 (E)
*
*
*
*
*
*
PDJ-A640 IM
Advertisement
Table of Contents
