Table of Contents
Advertisement
Contents
Trademarks
PDJ-A640 IM
The following is a summary of all the sections of this manual.
Section 1
Unpacking and Packing
This section describes the package of the PDJ-A640 and the accessories.
Section 2
Installation Condition
This section describes the precautions on the operating environment of the PDJ-
A640 and on the installing location. The section also describes how to move the
PDJ-A640, and the space required for maintenance.
Section 3
Installation Procedure
This section describes how to secure the PDJ-A640 to the floor and the ceiling, and
how to set the system control unit. The section also describes the installation of the
PDW-1500/PDW-HD1500/PDW-F1600/PDW-F70/PDW-F75, cable connection at
the rear side, how to turn on the power, and how to handle the optical disc unit.
Section 4
Input/Output Interface
This section describes the information regarding the connection on the system
controller block of the PDJ-A640 (connecting connectors and cables, and input/
output signal of the connectors).
Section 5
Installation and Setting When Connecting the PDJ-CS10
(CART IF) to the CART
This section describes the necessary procedures for installation and setup when
connecting the PDJ-CS10 (CART IF) to PDJ-A640.
Section 6
SNMP
This section describes SNMP (Simple Network Management Protocol).
Trademarks and registered trademarks used in this manual are follows.
. Ethernet is a registered trademark of Xerox Corporation.
. XDCAM, Professional Disc and MMStation are trademarks of Sony Corporation.
5 (E)
Advertisement
Table of Contents
