Printing On Roll Paper; Printing Area And Margins - Epson STYLUS PHOTO 895 Manual

Proof Sign-off:
T.Kubota CRE Nakano
N.Nomoto
editorname
The roll paper is now loaded. Next, set up the printer software
and try printing. For details on setting up the printer software,
refer to "Printing on Roll Paper" on page 4-13.

Printing on Roll Paper

Once you have prepared your roll paper and it is loaded in the
printer, you must make settings in the printer software in order
to print.
Note:
Always check the ink levels before printing on roll paper as replacing
ink cartridges while the roll paper is loaded can smear the paper.
Do not select A4 or 100 × 150 mm sheet paper for the Paper Size
setting when roll paper is loaded in the sheet feeder. Doing so causes
unnecessary paper to be fed after each print job. If you have already
started printing, press the Cancel button. Wait until the printer
stops printing and feeding paper. Cut off the paper at the back of the
printer, then turn off the printer. The remaining paper is ejected.

Printing area and margins

You can change the printing area and the margins for roll paper
with the printer driver settings. There are two margin settings.
One setting creates a 3 mm margin on both sides of your printout.
The other setting prints with no margins on either side of your
printout.
Follow the steps below to change the margins between pages of
printed data.
1. Select Roll Paper as the Paper Source in the printer driver.
R4C706
long.bk
A5 size
7/19/01
Using Roll Paper
R
Rev. C
ROLL.FM
4-13