Printing On Roll Paper - Epson Stylus Photo 875 DC Manual

Printing on roll paper

Once you have prepared your roll paper and loaded it into the
printer, you must make the printer driver settings before you can
print.
One of the first things you should decide is what width of roll
paper you will be using. This will determine what Paper Source
setting you will need to make. Select Roll Paper as the Paper
Source in the printer driver if you are printing on A4 or 329-mm
width roll paper. If you are using 89- or 100-mm width roll paper,
select Roll Paper or Roll Paper [Zero Margins]
below for details.
With Roll Paper selected as the Paper Source, a
3-mm margin will be left along both sides of the
paper. A 36-mm margin will be inserted between
print jobs.
In printing, the top margin above the print data
will be set to 20 mm.
When printing is done, press the
button once to print a guide line for cutting about
12 mm from the bottom of the print data.
To print out the next page after pressing the
load/eject button again, the space between the
two blocks of print data will be about 36 mm.
With Roll Paper selected as the Paper Source,
when printing data which spans multiple pages in
your application, a 3-mm margin will be left along
both sides of the paper. The margin between
pages will be set to 0, but the margin between
print jobs will remain 36 mm
1-22
Paper Handling
E
load/eject
E
.
Refer to the table