Remove Existing Interface Board/Placeholders From The Projector; Barco Projector Placement - GDC SR-1000 Installation Manual

Standalone integrated media block
Hide thumbs Also See for SR-1000:
Table of Contents

Advertisement

2.INSTALLING SR-1000 INTO THE PROJECTOR
2.1 Remove existing interface board/placeholders from the
projector
Before installing the SR-1000, check the sections below to ensure proper placement.

2.1.1 Barco Projector Placement

Figure 3 shows an interface board (with SMPTE 292 inputs) connected to a Barco projector.
This board must be removed in order to install the SR-1000, as shown in Figure 4.
INSTALLATION MANUAL FOR SR-1000
STANDALONE INTEGRATED MEDIA BLOCK™
Figure 3: Remove interface board from Barco projector
Figure 4: SR-1000 Placement on Barco projector
- 8 -
th
February 07
, 2022

Advertisement

Table of Contents
loading

Table of Contents