Connection Requirements - GDC SR-1000 Installation Manual

15. SR-1000 INPUT AND OUTPUT
Sr. No. Device Type
1 Connection to Digital Amplifiers
2 Connection to Hi/Vi-N Devices
3 Connection to 4D systems
4 Connection to D-Box
INSTALLATION MANUAL FOR SR-1000
STANDALONE INTEGRATED MEDIA BLOCK™

15.6.2.1 Connection Requirements

Connect the 8-channel Digital AES3 outputs (1-8) of the
SR-1000 available on the A-top connector of the IMB
*
directly to the Digital Amplifiers or Crossovers using good
quality shielded CAT6 cable(s).
The AES pair 11/12 is available on the RJ45 Connector
labeled A-bot on the IMB and can be connected to the
Hi/Vi-N device either directly or via a 2 channel D/A
Converter depending on whether the Hi/Vi-N device
accepts digital (AES3) or analog inputs.
Appropriate cable and connectors should be chosen,
keeping in mind the connectors used on the Hi/Vi-N
device and 2-channel D/A converter (if used).
AES output pair 15 and 16 on the SR-1000 carries the
LTC signal used to sync 4D systems like ScreenX, 4DX
and MX4D to the SR-1000.
Note: The
must be checked.
The AES pair 15/16 is available on the RJ45 Connector
labeled A-bot on the IMB and can be connected to the
LTC input on the 4D System.
Appropriate cable and connectors should be chosen
keeping in mind the connector used on the 4D system.
AES output 13 on the SR-1000 carries the Motion Data
signal used by D-Box (assuming DCPs follow the 16-
channels ISDCF recommended channel order).
The AES pair 13/14 is available on the RJ45 Connector
labeled A-bot on the IMB and can be connected to the
D-Box system.
Appropriate cable and connectors should be chosen
keeping in mind the connector used on the D-Box
system.
Description
'Enable LTC Output on Channel 15/16'
- 47 -
option
th
February 07 , 2022