Table of Contents
Advertisement
Review Final Checklist before Operation
•
A visual inspection should be made prior to each use of the Positioning Jacks. The inspection
should check for abnormal conditions such as cracked welds, damaged or loose and missing
parts or wear.
•
Any product that is found to be damaged or operates in an abnormal manner, must be removed
from service immediately.
•
Any product that operates abnormally must be removed from service until repaired by a qualified
repair service center.
•
If the product is accidentally subjected to an abnormal load or shock, it must be taken out of
service immediately and be inspected by a qualified service center.
⚠
WARNING
⚠
WARNING
⚠
WARNING
⚠
WARNING
⚠
WARNING
⚠
WARNING
⚠
WARNING
⚠
WARNING
⚠
WARNING
GoCart™ Rolling Car Dollies
Do not exceed the rated capacity of 1,500 lbs / 680 kg for each Positioning Jack.
Overloading can cause damage to, or failure of the Positioning Jack.
Do not operate the Positioning Jack on inclined surfaces! The Vehicle Positioning
Jacks are designed for use only on hard level surfaces. Use of the Jacks on other
than hard level surfaces can result in instability of the Jack and possible loss of the
Load on the Positioning Jack.
Keep hands and feet clear of all Pinch Points.
Failure to heed these warnings may result in loss of Load, damage to the
Positioning Jacks, and/or failure resulting in property damage, personal or fatal
injury.
Because of the potential hazards associated with lifting and moving vehicles,
alterations shall not be made to the product.
The Positioning Jacks are to be operated by properly trained personnel only.
Operation by untrained personnel may result in injury and/or property damage.
The Vehicle Positioning Jacks allow a Vehicle to be moved easily. Be aware that
sloped surfaces and uneven loading may result in unanticipated movement of the
Vehicle as soon as the Vehicle Tires are free from the floor surface.
The Positioning Jacks cannot be used to hold a load on a permanent basis. Use
them to hold a Vehicle, perform the desired work, then immediately lower the
Vehicle back to the ground.
Do not attempt to push the Positioning Jacks over obstacles. They are designed to
be used on level and smooth surfaces only.
7
P/N 5900207 — Rev. B — September 2021
Advertisement
Table of Contents
