Table of Contents
Advertisement
Manual. RCD-1500, and RCD-1500EX Rolling Car Dollies, Setup and Operation Manual, Manual P/N 5900207,
Manual Revision B, Released September 2021.
Copyright. Copyright © 2021 by BendPak Inc. All rights reserved. You may make copies of this document if you
agree that: you will give full attribution to BendPak Inc., you will not make changes to the content, you do not gain
any rights to this content, and you will not use the copies for commercial purposes.
Trademarks. BendPak, the BendPak logo, Ranger, and the Ranger logo are registered trademarks of BendPak
Inc. All other company, product, and service names are used for identification only. All trademarks and registered
trademarks mentioned in this manual are the property of their respective owners.
Limitations. Every effort has been made to use complete and accurate instructions in this manual. However,
product updates, revisions, and/or changes may have occurred since this manual was published. BendPak
Ranger reserves the right to change any information in this manual without incurring any obligation for equipment
previously or subsequently sold. BendPak Ranger is not responsible for typographical errors in this manual. Feel
free to contact us at any time to get the latest information about any product: rangerproducts.com.
Warranty. The BendPak Ranger warranty is more than a commitment to you: it is also a commitment to the
value of your new product. For full warranty details, contact your nearest BendPak Ranger dealer or visit
bendpak.com/support/warranty. Go to
online form to register your product (be sure to click Submit).
Safety. Your new product was designed and manufactured with safety in mind. Your safety also depends on
proper training and thoughtful operation. Do not set up, operate, maintain, or repair the unit without reading and
understanding this manual and the labels on it;
Owner Responsibility. In order to maintain your product properly and to ensure operator safety, it is the
responsibility of the product owner to read and follow these instructions:
•
Follow all installation, operation, and maintenance instructions.
•
Make sure product setup conforms to all applicable local, state, and federal codes, rules, and regulations,
such as state and federal OSHA regulations.
•
Read and follow all safety instructions. Keep them readily available for operators.
•
Make sure all operators are properly trained, know how to safely operate the unit, and are properly supervised.
•
Do not operate the product until you are certain that all parts are in place and operating correctly.
•
Carefully inspect the product on a regular basis and perform all maintenance as required.
•
Service and maintain the unit only with approved replacement parts.
•
Keep the manual with the product and make sure all labels are clean and visible.
•
Only use this product if it can be used safely!
bendpak.com/support/register-your-product/
do not use this product unless you can do so safely!
and fill out the
Advertisement
Table of Contents
