Specifications; Setup - Ranger GoCar RCD-1500 Setup And Operation Manual

Specifications

Model
Holding capacity
Load Rating Total
Tire Width Capacity
Tire Diameter Capacity
Overall Height
Casters Diameter
Stowed Dimension

Setup

This section describes how to prepare your Positioning Jacks for use.
Note:
To setup your Car Dollies (Positioning Jacks):
1. Remove the Positioning Jacks from the packaging.
2. Perform the Bleeding Procedure detailed below. Air may have become trapped in the Hydraulic
System during shipment or storage. Air in the Hydraulic System may make the Pedal feel "Spongy"
or prevent the Positioning Jack from to lifting the load.
Bleeding Procedure:
• Open the Release Valve by turning it counterclockwise. Do not turn the Release Valve
counterclockwise more than two full turns. Hydraulic Fluid will leak from the Positioning Jack.
• Pull the Rollers apart to the fully open position.
• Carefully remove the Foot Pedal Stow Hook (the Pedal is Spring-loaded) and pump the Foot
Pedal at least five full strokes.
• Close the Release Valve.
3. Your Positioning Jacks are ready to use.
GoCart™ Rolling Car Dollies
21" x 24" / 533 mm x 610 mm
Setup information applies to both models.
RCD-1500
1,500 lbs. / 680 kg
6,000 lbs. / 2,722 kg
12" / 305 mm
15 – 28" / 381 – 711 mm
6" / 152 mm
4" / 102 mm
6
RCD-1500EX
1,500 lbs. / 680 kg
6,000 lbs. / 2,722 kg
13" / 330 mm
19 – 37" / 483 – 940 mm
6" / 152 mm
4" / 102 mm
25" x 26" / 635 mm x 660mm
P/N 5900207 — Rev. B — September 2021