Howard Miller FT46G Instructions

Power Button

• Press the POWER button to turn ON or OFF.
• When the replace is ON, the power icon indicator light will
be green.
• When the replace is OFF, the power icon indicator light will
be red.
• If heater is working before power OFF the fan will have a 20
second shuto delay.

Mode Button

Press the MODE button to cycle through the di erent functions.

Temperature Mode

• Press UP arrow or DOWN arrow to set the heater's
temperature: 59ºF - 86ºF (15ºC - 30ºC), ON, OF (o ).
• Hold the MODE button for 3 seconds to change between ºC
or ºF. This function is only available if using the control panel.
• When the ambient room temperature is higher than the set
temperature, the heater will shut o automatically.

Timer Mode

• Press UP arrow or DOWN arrow to adjust the timer setting to
automatically shut o from 0 hour (OFF) to 9 hours with 0.5
hour intervals. Never leave the replace unattended.

Flame Brightness Mode

• Press UP arrow or DOWN arrow to adjust the
brightness: F0 (no ame) to F5 (brightest).
CLEANING INFORMATION:
• Make sure the replace is o , unplugged, and the heating element is cool whenever you are cleaning the replace.
• Clean the outside surfaces using a water-dampened, soft, and clean cloth. DO NOT use brass polish or household cleaners.
• Periodic cleaning/vacuuming of the air intake and exhaust vents is recommended.
• Keep clear of dust and debris that could block air ow.
REPLACING THE REMOTE CONTROL BATTERY:
• The battery should be removed if the product is to be left unused for an extended period of time.
• When the remote control stops operating or its range seems reduced, it is time to repave the battery.
• To replace the battery, insert a new CR2025 lithium battery ensuring the polarities of the battery match the inside of the battery
compartment.
Fireplace Instructions

Operating Instructions

ame

Care and Maintenance

Child Lock

Child Lock function is only available by using the control panel.
Activate Child Lock
• When the replace is ON, hold the POWER button for 10
seconds to activate the Child Lock function. "E3" will be
displayed to indicate the Child Lock function has been
activated.
Deactivate Child Lock
• To deactivate the Child Lock function, hold the POWER
button for 10 seconds.

Other Features

• Each time the replace is plugged in or main power is
interrupted, the fan and heater will turn on for 5 seconds.
• The replace has a memory function with last settings for
heating level and ame brightness e ect, unless the main
power to the unit has been interrupted.
• The replace includes an automatic protection system that
will shut o the replace to prevent overheating. If the
replace is at risk of overheating, the front panel will display
"E1" and the heater will shut o .