Makita DJR181 Instruction Manual page 8

Hook
► 1 . Hook
CAUTION:
• Depress the lock-off button from A side to lock
the switch trigger in the OFF position. (See the
section titled " switch action " .)
• Never hook the tool at high location or on poten-
tially unstable surface.
The hook is convenient for hanging the tool temporarily.
To use the hook, simply lift up hook until it snaps into
the open position.
When not in use, always lower hook until it snaps into
the closed position.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Installing or removing the saw blade
CAUTION:
• Always clean out all chips or foreign matter
adhering to the blade, blade clamp and/or slider.
Failure to do so may cause insufficient tighten-
ing of the blade, resulting in a serious injury.
To install the saw blade, always make sure that the
blade clamp lever is in released position
insulation cover before inserting the saw blade. If the
blade clamp lever is in fixed position, rotate the blade
clamp lever in the direction of the arrow so that it can be
locked at the released positon
1
on the
.
8 ENGLISH
2
► 1 . Blade clamp sleeve 2. Released position 3. Fixed
position
Insert the saw blade into the blade clamp as far as it will
go. The blade clamp lever rotates and the saw blade is
fixed. Make sure that the saw blade cannot be extracted
even though you try to pull it out.
► 1 . Blade
NOTE:
• If you do not insert the saw blade deep enough,
the saw blade may be ejected unexpectedly
during operation. This can be extremely
dangerous.
If the lever is positioned inside the tool, switch on the tool
just a second to let the blade out as shown in the figure.
Remove the battery cartridge from the tool.
To remove the saw blade, rotate the blade clamp lever in the
direction of the arrow fully. The saw blade is removed and
the blade clamp lever is fixed at the released position
► 1 . Blade clamp lever
1
3
1
1
.