Charging The 12 V Battery; Servicing The 12 V Battery; Replacing A 12 V Fuse-Block Fuse - Toro Reelmaster 5010-H Operator's Manual

3. Apply a coat of Grafo 112X (skin-over) grease,
Toro Part No. 505-47 to the battery posts and
battery-cable clamps.
4. Slide the rubber boot over the positive
battery-cable clamp.
5. Assemble the cover over the battery, inserting
the tabs of the cover into the slots in the battery
tray.
6. Close and latch the screen; refer to
Screen (page 44).

Charging the 12 V Battery

1. Disconnect the battery; refer to
the 12 V Battery (page
2. Connect a 3 to 4 A battery charger to the battery
posts.
3. Charge the battery at a rate of 3 to 4 A for 4 to
8 hours.
4. When the battery is charged, disconnect the
charger from the electrical outlet and battery
posts.
5. Connect the battery; refer to
V Battery (page 57).

Servicing the 12 V Battery

Service Interval: Every 50 hours
Note:
Keep the terminals and the entire battery case
clean because a dirty battery will discharge slowly.
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Open the screen; refer to
(page 43).
3. Check the condition of the battery.
Note:
Replace a worn or damaged battery.
4. Disconnect the battery cables, and remove the
battery from the machine; refer to
the 12 V Battery (page
5. Clean the entire battery case with a solution of
sodium bicarbonate (baking soda) and water.
6. Rinse the case with clean water.
7. Assemble the battery to the machine and
connect the battery cables; refer to
12 V Battery (page
8. Close and latch the screen; refer to
Screen (page 44).
Closing the
Disconnecting
57).
Connecting the 12
43).
Opening the Screen
Disconnecting
57).
Servicing the
58).
Closing the
Replacing a 12 V
Fuse-Block Fuse
The fuse block is in the control arm.
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Open the 2 latches that secure control-arm cove
to the control arm, and remove the cover
99).
1. Control-arm cover
3. Replace the open fuse
same fuse type and amperage rating.
1. Fuse block
58
43).
Figure 99
2. Latch
(Figure 100) with the
Figure 100
2. Fuse decal (inside the
control-arm cover)
(Figure
g375760
g375761